xboxscene.org forums

Author Topic: Upgraded Hard Drive Doesn't Like Ide Location  (Read 137 times)

mai0f

  • Archived User
  • Newbie
  • *
  • Posts: 38
Upgraded Hard Drive Doesn't Like Ide Location
« on: February 25, 2013, 07:02:00 PM »

hi all...  my old (500gb) was getting full, so i decided to upgrade it to a 1TB i had laying around.. i researched around, and found a SATA/IDE adapter for it. after much frustration, i discovered my problem... when the hard drive is connected normally (XBOX / DVD / HD) it'll give me an error 13. but when i connect it XBOX / HD / DVD, it works fine... my problem now is that the IDE cable length is too  short.. i even flipped the cable around, but still, just BARELY too short...

- using x2.3b pro with x2 5035 v16plus
-the adapter (http://www.newegg.co...N82E16812240012) is set to CS

any suggestions (other than getting a longer cable hopefully)?



thanks,
-m
Logged

ttsgeb

  • Archived User
  • Jr. Member
  • *
  • Posts: 60
Upgraded Hard Drive Doesn't Like Ide Location
« Reply #1 on: February 26, 2013, 01:34:00 PM »

Try it again with the jumper set to master.
Logged

mai0f

  • Archived User
  • Newbie
  • *
  • Posts: 38
Upgraded Hard Drive Doesn't Like Ide Location
« Reply #2 on: February 26, 2013, 09:43:00 PM »

QUOTE(ttsgeb @ Feb 26 2013, 09:34 PM) View Post

Try it again with the jumper set to master.



thank you, but it's still a no-go. i've tried master, slave, cs, and no jumper... for some reason, it only likes to work when it's plugged in before the dvd..    uhh.gif

i've also tried a different ribbon cable, and another (modded) xbox. all give same results.
Logged