Print

[antisniperspy]

QUOTE(Maximize @ Jul 3 2010, 10:53 PM)

I just wish someone would host these SMC's and patched xbr files

They are its called xbins. Just grab a xbr pached smc then use the tool. Cant get any easier than that.

[sm32]

Hi guys I have a Zephyr 360 which was giving me a bunch of E79 50% of the time or so, so I decided to rewire the RF point to the AUD_clamp point. As soon as I flashed the new firmware and restarted the 360, I got RROD (0022), not E79 as expected. I have redone my soldering connections numerous times - did I screw up in how I created my nand image, or is my soldering just terrible (after doing it so many times its almost messy now).

took freeBOOT.bin (that i originally flashed from LPT port), extracted SMC from 360 Flash Tool 0.94.
ran smc_io SMC_dec.bin SMC_output.bin
Injected SMC_output.bin into freeBOOT.bin via "import" in 360 Flash Tool 0.94.
Used 360Flash to flash to console.

Xell doesn't load by hitting eject (get RROD) and a normal power button push also yields RROD after about 15-20 seconds.

Attached are pictures of soldering. No picture of the jumper wire -- that didn't change. Apologies for cell phone camera quality.

leaving j2d2.1 and j2d2.2 from the bottom side.


going to FT2P3


going to Q2N1 (aud clamp)


(yes there's a lot of solder on that last one. i can take it off if need be..no worries)

Thanks!

[TeePee78]

I am trying to do just the bugfix before trying any wiring...I am new to all of this.

Here is the steps I have taken:

1. Dumped Nand from FSD Nand Flash Tool
2. Extracted SMC_dec.bin using v.94 Tools
3. Ran the patcher "smc_io SMC_dec.bin SMC_patched.bin 83 28 C0 03"

Now this is where I am lost..I am supposed to rencrypt the smc and then import it back into my nand..but I don't know how to do this step

Help would be appreciated, Thanks.