Hi Frosty,
Sorry for bothering you as many others but I would be grateful for your help.
I am stuck at the beginning.
I am using CK3 as a power source for DVD-ROM Samsung MS-28 iX 1.4, and using VIA VT6421 PCI card.
Followed all the instructions and passed Port set successfully for your VT6421 SATA card.
COM port "1" set successfully for your serial cable.
Typed "yes" on NTFS for DOS... then "samsung", typed folder name as asked ... "Folder name "Samsung" saved!
Then this instructions come out:
1. Connect SATA/power cables to the TS-H943 drive - DONE
2. Press ENTER -Done
3. Disconnect power cable from TS-H954 drive (leave SATA connected) - DONE
4. Press the number on the keyboard for 'XTREME Pri Master'
I've got offered only this:
1: IDE Sec Slave
When I choose 1, it says Port:170, Master/Slave: b0
And after that nothing happens.
I wait for 15 sec., recconect the power cable but only escape button make any difference.
Folders on HDD were created, but stays empty.
In all steps, only MTKFLASH appears with same instructions.
Any help will be apriciated.
Thanks.