Topic: Free60 JTAG/SMC XeLL Hack for Zephyr Motherboards (Read 681 times)

niai · « **Reply #30 on:** October 29, 2009, 09:47:00 PM »

yes look up bout the rebooter but live would be very risky and if you want homebrew i think your going to have to kiss live good bye

lovejelly · « **Reply #31 on:** November 02, 2009, 07:09:00 AM »

Hi all

New to the forums, what type of diodes do i need for the red and yellow wires?

Many thanks

niai · « **Reply #32 on:** November 02, 2009, 09:13:00 AM »

any would work i would say

dont quote me on this but even a led(light emitting diode) would work i would say
(wouldnt try it though)

shawnmos · « **Reply #33 on:** November 06, 2009, 01:05:00 AM »

I flashed the zephyr_hack_updxell.bin and the xbox won't boot. I get error code 0020 or 0022. However, when I flash it back to the original bin it boots.

niai · « **Reply #34 on:** November 06, 2009, 04:17:00 AM »

did you keep the jtag points on the board (the place where you bridged the points 2 of them with diods)

niai · « **Reply #35 on:** November 07, 2009, 05:58:00 AM »

np you need to keeep them in some people remove them thinking thy are just needed to read/write the nand but there there to trigger the exploit

you shore you have a zephyr?

niai · « **Reply #36 on:** November 07, 2009, 06:30:00 PM »

no just flash the file to the xbox as it is

try re-soldering the lpt cable maybe the writing part is messed up

shawnmos · « **Reply #37 on:** November 08, 2009, 12:07:00 AM »

Just resoldered and it's still not working. RROD error 0020. I was able to get a Xenon board to work fine. Not sure what's wrong with this one. DB1F1 did get messed up though. I scraped it down and was able to attach it, so that's probably not it.

Author Topic: Free60 JTAG/SMC XeLL Hack for Zephyr Motherboards (Read 681 times)