Print

[mystiquesbs]

So with all the other benq's i have done I just used jungleflasher and it read it and then went to firmwaretool32 and it showed the key fine. But for this one it does the read but then say's key not found when it went to firmwaretool32.

I have also used dvdflash32 and this reads it aswell. When I try to open the orig.bin in jungleflasher it again says key not found.

If I use firmware toolbox to view the orig.bin it shows the exact same key for all of the reads that I did using both sets of software.

Is this orig.bin correct or is there something wrong with it?

Can I use the key I am getting from firmware toolbox and insert it into the ix1.5 for benq?

Is there any other way to confirm that this orig.bin is correct?

thanks.

[mystiquesbs]

yeh i used dosflash32 and jungleflasher and got the same key in both (this was using firmwaretool to have a look at the key). But when I tried to open it in the firmware32 thing in the jungleflasher it says no key found. I will try iprep tonight and see if it works