Print

[psp2xbox]

Hi all, had a slight issue before doing a VCC on a Samsung MS28, whereby when i removed the resisitor ive also removed the bottom pad point. because the pad point is gone i can not run a multi meter to test where the track runs too, and i cant visually see where this trace point runs too...any help is appreciated

[moreniu]

Well, i got the same problem, i have no idea where to solder the bottom part what i removed, any thoughts?

[moreniu]

Forgot to post here, i got the problem solved, in my case, the base what got broke was the inside one, the one what is in the same track of the capacitor right at the side, the solution was jump it to the capacitor, done

[paradroid]

QUOTE(moreniu @ Dec 20 2006, 11:35 AM)

Forgot to post here, i got the problem solved, in my case, the base what got broke was the inside one, the one what is in the same track of the capacitor right at the side, the solution was jump it to the capacitor, done (IMG:style_emoticons/default/wink.gif)

i' have the same problem here,
but i dont understand what you mean with capacitor ?
someone has a simply tip or picture how to fix this ?



top
   
4
0
8

bottom

the bottom one is broken (IMG:style_emoticons/default/sad.gif)

a picture is here.

http://img521.imageshack.us/img521/6343/408sw5.jpg

This post has been edited by paradroid: Dec 21 2006, 10:33 PM

[moreniu]

Sorry my delay to reply.

Look here :

(IMG:http://img19.imageshack.us/img19/6062/408sw5aa0.jpg)

If you broke the base what u painted as ORANGE, you can use the capacitor in paralalel with the r408:

(IMG:http://img184.imageshack.us/img184/1264/408sw5eq5.jpg)

On the picture I showed where the capacitor is. The problem is that your drive board have way much epox and you cant see the capacitor down there lol!

This post has been edited by moreniu: Dec 31 2006, 12:44 AM