Hopefully my hosting holds up. Taken from the above posted site. I wanted to post more but the site is pretty much gone for now.
Removing the Outer ShellThe first step is to remove the outer plastic shell that conceals the innards of the system. To do this, you must start by removing the face plate. Take a look at the front of the Xbox 360 and insert your thumb into the door that covers the two USB ports on the right of the unit. With your other hand squeezing the upper and lower sides of the face plate, pull out the face plate with your thumb. With not much force, the face plate should pop right off.
(IMG:
http://www.members.optusnet.com.au/s.gilmore/xbox360/face_removed_small.jpg)
After the face plate has been pulled off you will see a silver MS sticker covering a gap; remove this. You will also see four small clips locking the top half of the plastic shell to the bottom half. Do not attempt to wedge the clips out at this point.
With some care, gently bend outwards, the right gray ventilation shield on the right side of the unit so that you can see a bit inside. You will notice that the gray side piece attaches to both the bottom and top white chassis. Now look through the holes on top of the unit to locate the areas where the gray side pieces attaches to the white body. What you need to do is take the long but thin metal stick and push down, through the white holes (located on both the top and bottom of the Xbox 360) where the clips of the gray side pieces connect. Slowly pull out the gray pieces away from the unit while unlocking the clips and eventually the gray piece will release itself.
(IMG:
http://www.members.optusnet.com.au/s.gilmore/xbox360/side_plates_small.jpg)
(IMG:
http://www.members.optusnet.com.au/s.gilmore/xbox360/harddrive_small.jpg)
To remove the left gray piece, you must first remove the hard drive unit by pressing the button located on the unit itself. Then apply the same procedure used to remove the right gray ventilation piece -- except when you reach the bottom clip of the piece, you most remove the rubber feet located directly below, to reveal a hole where you can insert the metal stick.
Once you have both side gray pieces removed, you have essentially removed the main locking mechanism that holds the top and bottom shells together. At this point, return to the front of the unit and turn the entire unit upside down. Using a flat head screw driver or wedge, gently pry up the 4 clips holding the top shell to the bottom. Once the clips are unlatched, slowly lift up the front of the bottom shell about an inch.
(IMG:
http://www.members.optusnet.com.au/s.gilmore/xbox360/rear_small.jpg)
(IMG:
http://www.members.optusnet.com.au/s.gilmore/xbox360/separation_small.jpg)
The last step to removing the bottom shell cover is to insert a thin and small plastic stick into the thin rectangular holes on the rear. The reason the front of the bottom shell needs to be lifted is to prevent the rear latches from reattaching themselves. Slowly insert the stick into each rectangular opening. You should hear a click sound for each clamp you unlatch. Once complete, you may lift off the bottom shell covering.
Looking inside the unit, you will notice that there are 14 silver screws (6 of which are long) and 8 black screws. Using your start bit screw drivers, remove the silver screws using a size T12 screw driver and the black ones using a size T7. Once you have all the screws removed, flip the Xbox 360 right side up and lift up the top plastic shell. You should now be greeted with the internals of the Xbox 360.
(IMG:
http://www.members.optusnet.com.au/s.gilmore/xbox360/underside_small.jpg)
(IMG:
http://www.members.optusnet.com.au/s.gilmore/xbox360/no_cover_small.jpg)
Author
Topic: How To: Opening Up An Xbox 360 (Read 463 times)