Print

[insertionpics]

cokebottles: THANK YOU

i made a patch that went under the board from pin 15 to pop out of the case screw hole before the power block, i patched it to the orange double wire 3.3v which was a bit tricky because there are 2 wires in there already. but i now get 3.3v to pin 15 and therefore get the 3.3v LED on the x3 lit up. i am not out of the woods yet as i have not fully assembled the rest but the X3 seems to be working.

ill post pics of the power block patch and some tips after if put it together.