Print

[Antman1]

Well today before reading up on anything I went to get into my Netflix and was prompted for a dash update.  I figured what tha hell and let it do its thing.  At the very end my console went to reboot and nada.  it wont boot even to the retail dash.  I then started reading and found that some said the CB was updated to a 2 part CB now on Fats and that they weren't sure on the Slims.  Well I can confirm the CB has changed and I am not sure if that means the Glitch board will need new timings or what but I think I will have to unhook the Glitch board now just so I can load my stock dash.  below is a pick of my old dash and CBs and the new dash I got today.  

(IMG:http://unmrkd.net/heavenlymodz/wp-content/uploads/2012/02/MYMYMY.jpg)

[Definitely Wapner]

Would there be any way, if you already had an older NAND and CPU key that you might just be able to flash the old NAND back?

[Antman1]

I'm not entirely sure.  I tried old nand with correct LDV Values for the glitch and no luck yet.  Trying now to just get it to load the original dash again.

I got my original dash working again.  If you have the Glitch Board powered on with the original stock dash now it will not boot.  I removed the power wire on the Glitch Board and it fired right up on my Stock Dash.

This post has been edited by Antman1: Feb 16 2012, 09:50 PM

[NeTRaVeR]

Hey Antman....

I too fell into the same trap and my RGH dual boot is now dead! Let me know when you have a fix for yours as I would hate to  lose this console due to my stupidity!

I have seen the guys at Xecuter seem to have "fixed" the 14717 update but I can't tell whether this fix needed to be applied before the 14717 update was run or after?

Thanks in advance for all your posts thus far.... love your work!