Topic: 1st Jasper Not Getting Nowhere (Read 161 times)

death69inc · « **Reply #15 on:** September 28, 2010, 12:02:00 PM »

wondering if a bad drive can cause xell nto to boot?

??
it does eject but the drive cant read somethign worng with the board not the laser

Looouky · « **Reply #16 on:** September 29, 2010, 08:20:00 AM »

no bad drive, will not matter it should still boot into xell. PS you should be following my new tutorial in my signature especially if are doing AUD_CLAMP.

Also used the xellous file first in the new jasper zip, if that doesn't work use the xell.

death69inc · « **Reply #17 on:** September 29, 2010, 06:41:00 PM »

used your tut along with many others

the aud clamp i used was linked to your boxxdr etc but it did nto work either

used xellous and xell nothing worked

funny the one i wanted the most wort work lol

ravendrow · « **Reply #18 on:** October 03, 2010, 12:29:00 PM »

so i was wondering did you buy this as a j-tagable console? if you did then your problem might be damage to your j2d2 points i got a falcon a while back that once the guy changed jtag wiring out for the new wiring he couldn't get it to work again it was because he damaged the points i had to rewire from under the gpu to get it to work again (not easy and not fun) i hope this isn't the case but good luck if it is

death69inc · « **Reply #19 on:** October 03, 2010, 05:05:00 PM »

ill re trace the j2d2 and see now i have slowed down agian i can put more time into this one

Author Topic: 1st Jasper Not Getting Nowhere (Read 161 times)