xboxscene.org forums

Author Topic: Nandpro Error 280 Programming Block ...  (Read 22 times)

p4r0l3

  • Archived User
  • Full Member
  • *
  • Posts: 194
Nandpro Error 280 Programming Block ...
« on: September 12, 2010, 09:12:00 AM »
This can be a problem with your wiring so you could try to rewire and fire it up again.

However, if it ALWAYS makes it past block 200 before throwing errors, you should just flash xellous (since it's only 2mb and is <200blocks.) Boot into xellous and use a USB stick to flash your full XBR image.

(As always, I'll have to recommend Freeboot over XBR. The procedure is the same as far as flashing)
Logged

norite

  • Archived User
  • Jr. Member
  • *
  • Posts: 84
Nandpro Error 280 Programming Block ...
« Reply #1 on: September 12, 2010, 10:47:00 AM »
Yeah, Thanks for that...after posting here I checked my wiring and resoldered the diode to the RoL. Not getting the 280 errors, so it was a bad solder. But I have a bad block at 135 and 018E, so I will remap those and try again.
Logged