Print

[jakl53]

Every step I move forward I run into more problems. I unsoldered everything and resoldered it and now I have three good dumps, none with bad blocks. They all open in Degraded and I have an exploitable CB. After flashing XBR and try to start up my xbox I get the RROD. The only thing I can find about this is that you dont have an exploitable CB, didnt inject KV or config, or have bad blocks. None of them are correct. So does anyone have any ideas?

[majinsoftware]

reflash one of the nand dumps and check if it rrods.
If no then its probly your jtag soldering.

[pink1]

Can you boot into xell.
What is your error code.
If you flash your nand back will it work.

[jakl53]

QUOTE(majinsoftware @ Aug 15 2010, 04:18 AM)

reflash one of the nand dumps and check if it rrods.
If no then its probly your jtag soldering.

I thought about this after posting. I reflashed my good image and its still RROD. Im about to check the error code now.
EDIT: I checked my code and its 0020, and noone seems to know what it is.

This post has been edited by jakl53: Aug 15 2010, 11:16 PM

[jakl53]

So I think I got it figured out. When I wrote xbr to my nand I didnt have my jtag wires soldered on because I had taken them off at one point for troubleshooting. So after receiving rrod after flashing my original dump back, I installed the jtag wires and reflashed. Now I can boot into xbr I believe. But no more rrod so im fine. Also if anyone runs across this problem I also injected the KV and config files after flashing.