Print

[Fr3shY]

Hey,

I'm getting the E79 whenever I flash XeLL and 3RRoD error code 0020 whenever I use the original nand which tells me that my soldering of the JTAG hack is correct. This also happens with XBR for some reason.

I have spent a little over 10 hours now on this "little" project and have had just about every scenario happen. I checked my soldering multiple times by going through pictures, and using a magnifying glass. I also resoldered everything 2-3 times now to confirm any errors.

I have had issues with no power which ended up being a short causing the red light on the PSU, I fixed it and then it changed to E79.

I am using the NAND-X and tried the QSB (which suck) and now use thin wire directly. I have dumped the nand multiple times successfully and compared them.

My falcon is exploitable cause its running 7371 and cb 5761.

The diodes are facing the right way on the JTAG and the jumper is from 4 to 7.

I have built the XBR image correctly multiple times, and even had the image created for me (yes I've tried injecting the rawkv, as well as the rawkv + config.

Oh yeah and taking out the JTAG wires allows me to boot up fine using the original NAND so it's not the xbox.

If I'm missing anything let me know and I'd be willing to try, messaging me on AIM would be the best... AIM: ViSHH360Mods.

Here are some pictures if you want to see my soldering:
http://img695.images...g/img0070z.jpg/
http://img203.images.../img0076oq.jpg/

Thanks!

[thwack]

You need to re-do your soldering - especially the J2D2 area as there may be bridged joints (see where your solder runs over traces - sometimes the pcb covering on them isn't thick and you can get shorts.