Print

[skforty]

I'm having a bit of trouble, when i open my dumps in the 360 flash dump tool v.0.91, i get "no fs root!"  But it does see that im on 7363 with CB version of 6750 and a jasper 4.0 16MB.  Can i still have homebrew, or is my CB version not compatible.  This is the image im seeing in 360 fdt



Any help would be appreciated!  

Thanks!

[vintage_guitar]

cb6750 is not exploitable

[skforty]

QUOTE(vintage_guitar @ Dec 18 2009, 03:34 PM)

cb6750 is not exploitable

Well, that really sucks

Thanks for the quick reply though

Time to get a new box.

[alucard_xs]

hi dudes,

my original nand is OK but when i flashed with xbr (injected the two needed files from my nand), my xbox starts alone with the middle green LED on ...

what can i do ?

i flashed several times with no success ( btw; flashing with my original nand works)

help needed

[matt_black_90]

QUOTE(alucard_xs @ Dec 20 2009, 05:57 PM)

hi dudes,

my original nand is OK but when i flashed with xbr (injected the two needed files from my nand), my xbox starts alone with the middle green LED on ...

what can i do ?

i flashed several times with no success ( btw; flashing with my original nand works)

help needed

did you remap badblocks? (if you had bad blocks?)

[alucard_xs]

I did not have bad blocks, my nand dumps were pretty good (no differences between the three I've made)

Now I've got 3 red lights ... I'm exhausted

[The1Hero]

Hello
 I was wondering if someone could help me rewrite a nand? i have all the files needed but for some reason the XBReboot just gives me e79, i tried it for 2 days now. and still e79, tried erasing nand then flashing it but still no go, if someone would be kind enough to help me out i would greatly appreciate it.

[beogradski-fantom]

QUOTE(The1Hero @ Dec 20 2009, 08:54 PM)

Hello
 I was wondering if someone could help me rewrite a nand? i have all the files needed but for some reason the XBReboot just gives me e79, i tried it for 2 days now. and still e79, tried erasing nand then flashing it but still no go, if someone would be kind enough to help me out i would greatly appreciate it.

Well, I had this problem too, I tried many times to rewrite it, just to find out that I didn't soldered the JTAG connections properly. That's the only thing I can think of right now that could cause the problem. Try to resolder the 3 wires. And make sure you solder the diodes in the right direction.

[WOWBOX]

Hi,

I went through the process of j-tagging, reading nand, injecting and then writing the new Xbrboot to the nand. The problem is that no dashboard will load on the xbox after, just the Xell readout. Did I overlook something?