Hi been reading the forum and the instructions to upgrade the firmware for my toshiba-samsung drive is to map my sata as ide ports 3+4 "Abit NF7-S2GNnforce2 SATA (mapped as IDE ports 3+4) - Compatible" I have a abi nf7s-v2 mobo, but have not found a topic on this, can any help me to find this info? also if I map the sata to ide will that mean I don't have to do the hexedit on the sata chipset?
Name ITE IT8211 ATA/ATAPI Controller
Manufacturer ITE Tech, Inc.
Status OK
PNP Device ID PCI\VEN_1283&DEV_8212&SUBSYS_00011283&REV_11\4&3B1D9AB8&0&3840
I/O Port 0x0000A000-0x0000CFFF
I/O Port 0x0000A400-0x0000A403
I/O Port 0x0000A800-0x0000A807
I/O Port 0x0000AC00-0x0000AC03
I/O Port 0x0000B000-0x0000B00F
IRQ Channel IRQ 19
Driver c:\windows\system32\drivers\iteatapi.sys (v1.3.2.0 built by: WinDDK, 27.00 KB (27,648 bytes), 28/10/2005 16:11)
Name Silicon Image SiI 3112 SATARaid Controller
Manufacturer Silicon Image
Status Error
PNP Device ID PCI\VEN_1095&DEV_3112&SUBSYS_61121095&REV_02\4&3B1D9AB8&0&5840
Driver c:\windows\system32\drivers\si3112r.sys (1, 0, 0, 50, 95.13 KB (97,408 bytes), 11/07/2006 01:12)
Name VAXSCSI Controller
Manufacturer (Standard mass storage controllers)
Status OK
PNP Device ID ACPI\PNPA000\4&45CB6047&0
I/O Port 0x0000FFE0-0x0000FFEF
IRQ Channel IRQ 9
Driver c:\windows\system32\drivers\vaxscsi.sys (, 217.90 KB (223,128 bytes), 21/03/2006 04:43)
Name SCSI/RAID Host Controller
Manufacturer (Standard mass storage controllers)
Status OK
PNP Device ID ACPI\PNPA000\4&45CB6047&1
I/O Port 0x0000FFA0-0x0000FFAF
IRQ Channel IRQ 9
Driver c:\windows\system32\drivers\dtscsi.sys (, 217.90 KB (223,128 bytes), 21/03/2006 23:10)
Author
Topic: Remapping And Hexedit Help (Read 54 times)