I am trying to restore a Hitachi drive from a v78 spoof back to it's original v47 state. I am trying to use jungle flasher with a SATA to USB kit powered by a team xecuter connectivity kit. The drive shows up in windows and I can see it in jungle flasher but when I try to do a restore it fails to dump the firmware and locks up. The drive appears to be in mode b because it takes two pushes to open & close the drive.
I have trie Maximus 4.6 toolbox as well and that locks up when try to do a restore. I can dump the firmware in maximus so can't understand what's wrong, is it the USB or is there something wrong with the drive?
Is it not really in Mode B, I send the USmodeB command from jungle flasher and it seems to have taken the command. Shoulds I not have the toggle switch turned on to mode B on the connectivity board when I plug in the drive to windows?
Also Jungle flasher picks the V78 drive option and raw mode for the restore command as it is spoofed as a v78, is this correct or should I use v47 and mode select.
Thanks for any help in advance
I had the same problem yesterday. U need to send mode b to drive then it has to be dumped as a 47 drive with ram upload and should then work no problems,