Print

[si5525]

I flashed my lite-on drive and followed the jungleslasher instruction using the cK3 with the probe.  I've flashed 4 drives but this one is giving me trouble.  Everything went well until i tried to play a original game and backup game.  The xbox starts to read the disk but says tray is open.  I think it has to do with the drive not locking after the flash.  

I know get Serial is bad every time. Please HELP!  What am I doing wrong.  

I used the following steps to prepare the drive

- Power off your PC computer
- Make sure CK3 On/Off switch is OFF
- Connect SATA cable from your VIA 6421 controller to the Liteon drive
- Connect the PC molex connector to CK3 pro
- Connect the power cable from the CK3 pro to Liteon
- Connect the the USB cable from CK3 pro to the PC USB port
- Turn ON Computer power and go intoo BIOS Screen or dual boot OS selection in order to pause bootup process
- Turn OFF CK3 pro power. Make sure the modeb light is blue
(If you have a CK3 probe it will lit blue as well)
- Press Eject button on CK3 pro.
- DVD Tray should will eject. Push in DVD tray more than half way in, with your hand.
- Turn OFF CK3 pro power!!!
-Let your PC boot into Windows XP
- Turn ON CK3 pro power


JungleFlasher 0.1.51 Beta
Session Started Wed May 13 21:08:27 2009


This is a 32 bit process running on 2 x 32 bit CPUs
Found 4 I/O Ports.
Found 3 Com Ports.
Found 4 windows drives.
Found 2 CD/DVD drives.

Sending DVDKey request to I/O port 0x2450 and COM4

................ Serial Data is bad,

DVDkey files extraction aborted!

Sending DVDKey request to I/O port 0x2440 and COM4

................ Serial Data is bad,

DVDkey files extraction aborted!

[eternalhax]

If you retrieved the keys fine to begin with I'm pretty sure your laser is toast... If you have a spare drive swap the laser & see.

http://forums.xbox-scene.com/index.php?showtopic=683927

http://forums.xbox-scene.com/index.php?showtopic=683592

[mackemsrule]

Don't know if it makes a difference while flashing lite-ons but modeb is only for hitachis, try leaving it off and pull the tray a bit more out so it's slightly over half way. and did you press  outro reset when you had finished to reset the drive

[si5525]

Yes. I tried everything you just said. I also used the outro reset after flashing.  I'm not new to flashing drives.  I've read a few threads that this has become a common thing.  I'm going to try to replace the lens tonight and see if that works. SUCKS!!!

If I fried the lens would that prevent me from re flashing?

This post has been edited by si5525: May 15 2009, 02:18 AM

[mackemsrule]

No it won't, just make sure if you upgrade the fw in the future to take the laser ribbon cable out while you do it, then it shouldn't happen again