I have done many Lite ons with iXtreme 1.4, switching the drives, but last night I tried to do one with 1.5 w/o swapping the drive. I have the initial release of iXtreme 1.5 and JungleFlasher, and went to flash it according to the directions provided with the firmware. I have a VIA 6421A based card and 360 Xtractor. When I went to erase it, it gave me an error that it failed and I believe it said that it was in an invalid state. I should have saved the log :-(.
I did not reset the drive after extracting the key, so it might have been in a busy state. Anyhow, after that the drive seems to be completely dead. It wont eject or anything and gives the flashing busy light when in the console. I cant access it in Windows either. It actually locks windows up when I have it connected. I was able to extract the keys and such, and in the meantime I am going to spoof it on a BenQ with 1.4, but does anyone know if there is anything I can do to salvage this? I am guessing not, but if there is any bad flash recovery method that would be awesome. Thanks in advance.