Topic: Hitachia 47 Wont Read Backups (Read 52 times)

Pierce711 · « **on:** February 03, 2020, 05:33:00 PM »

ok here is the problem i have a hitachia driv47 flashed with ixtreme 1.4rev1. i also have a blaster ne and my computer can read the drive when its put into mode B. But only says 5.14 mb on the disc how can i get it to read all of the data?

excaliburlives · « **Reply #1 on:** February 03, 2020, 06:08:00 PM »

Use XBC, it's perfect.

Ranger72 · « **Reply #2 on:** February 03, 2020, 06:13:00 PM »

Your blaster wont help much since you do not have a Samsung or BenQ drive flashed with 0800 firmware. You cannot make proper backups with a Hitachi drive.

Your best bet to make backups is to get a Kreon flashed drive and install it into your PC.

Pierce711 · « **Reply #3 on:** February 03, 2020, 06:14:00 PM »

WHEN I LOADED that up its says 5.14 mb do i just click whole copy and it will copy the whole disc or what do i do so thata way it reads it all

HackerSupreme · « **Reply #4 on:** February 03, 2020, 07:50:00 PM »

Ya it says that. When I flash my BenQ with 0800 it only says that the disc is like 7mb but the image always comes out to multiple gigs.

Just make sure that the "Complete Backup" bubble is clicked, and hit the start button.

scuba156 · « **Reply #5 on:** February 03, 2020, 11:33:00 PM »

read what me and ranger say very carefully, YOU CANNOT MAKE PROPER BACKUPS WITH A HITACHI.

get a kreon based drive

Author Topic: Hitachia 47 Wont Read Backups (Read 52 times)