xboxscene.org forums

Author Topic: Question About Certain Step In Tutorial  (Read 65 times)

nickolasj80

  • Archived User
  • Newbie
  • *
  • Posts: 49
Question About Certain Step In Tutorial
« on: May 05, 2008, 05:16:00 AM »

Reading through Textbook's Tutorial (specifically the section for BenQ drives), I have a question about the step before writing...

After reading is done, and hacked firmware has been created, he says to power off the 360, and then type fben xxx, then go through the power on/off procedure that you did to read the fw, right?

Secondly, what is the part about "You will then see this screen which tells you to power OFF the 360:"
But in the guide it has the pic with a red x through it, are you not supposed to do this step?
Logged

podger

  • Archived User
  • Hero Member
  • *
  • Posts: 501
Question About Certain Step In Tutorial
« Reply #1 on: May 05, 2008, 05:28:00 AM »

You are supposed to power cyle the PC and the 360 after you dump the drive.... This is a good time to go back into windows and confirm you have a good dump, firmtools should have given you a green light but it's no harm to be sure... Make some backups while you are there..... If the dump is not good DO NOT proceed

Just do what textbook tells you to do... He very rarely put anyone wrong...
Logged