Print

[coolnyc]

Ok this what happen

I solder 79 Passkey to the board along this way I fuck up the legs where you suppose to Solder ><
so i trace back to the chip. And solder 6-7 wires to each leg on the chip

I test with OHM meter to see if it have connectivity and Did not cross with each other that seem to be fine.

I solder 3.3v to where it suppose to be
and GND to where it suppose to be


i did not see blue light so I put It in Mode B using Slax


Windows Mode:

Open Firmware tool 4.6

Insert DVD movie - Matrix Reload Original

Close - press eject 3 times

Cyberlink PowerDVD pop up - OK that fine that mean the drive work under windows mode

Raw Dump - "Cannot Read Drive"


Oh i have VT6421 with 6421 Driver
I tried it with Port 0 and 1

What could be my problem?

Thank You