xboxscene.org forums

Author Topic: Help With Iprep  (Read 21 times)

BigSteel

  • Archived User
  • Hero Member
  • *
  • Posts: 577
Help With Iprep
« on: December 29, 2007, 11:11:00 PM »
I damaged the master port on my VIA6421 card.  I can use the secondary port if I manually use dosflash.  However, I would like to use iPrep instead.  When I setup my USB drive it automatically uses the master port (9800 in my case).  I need a way to change that to 9400.  Is there any way to do this?
Logged

podger

  • Archived User
  • Hero Member
  • *
  • Posts: 501
Help With Iprep
« Reply #1 on: December 30, 2007, 07:22:00 AM »
Hitachi's are not flashed using mtkflash, they are flashed from the iPrep GUI using the drive letter as a reference.
Logged

milamber

  • Archived User
  • Full Member
  • *
  • Posts: 119
Help With Iprep
« Reply #2 on: December 30, 2007, 08:16:00 AM »
QUOTE(podger @ Dec 31 2007, 12:22 AM) *

Hitachi's are not flashed using mtkflash, they are flashed from the iPrep GUI using the drive letter as a reference.

I think you might mean Firmware Toolbox as iPrep has nothing to do with flashing a Hitachi drive.

This post has been edited by milamber: Dec 30 2007, 04:18 PM
Logged

BigSteel

  • Archived User
  • Hero Member
  • *
  • Posts: 577
Help With Iprep
« Reply #3 on: December 30, 2007, 10:56:00 AM »
QUOTE(milamber @ Dec 30 2007, 08:16 AM) *

I think you might mean Firmware Toolbox as iPrep has nothing to do with flashing a Hitachi drive.


I am aware of that.  I am just wondering if Firmware Toolbox will pick up on the drive being connected to port 2 of the card.
Logged