Print

[Wateva]

K, managed to download the firmware,
I've started "benhack blablabla blabla"..
it erases the fw
it starts to inject the modded fw.
"Writing Bank 0..." and it's stuck.. what now??

it doesn't asks the new "Y/N" from mtkflash (dosflash)... it starts to flash right after I press enter where it asks me to turn off the BenQ drive..


any ideas??


-------------------------------------


Never mind...

it just needed a reboot.. just like some samsung drivers.. (IMG:style_emoticons/default/wink.gif)

thanks..


Mod, please, lock this.

This post has been edited by Wateva: Nov 8 2007, 03:23 AM

[jgarc016]

Ok, are you turning the power to the drive on and off in about 5 second intervals? it should take about 2 cycles or so.

[Wateva]

QUOTE(jgarc016 @ Nov 8 2007, 12:30 AM)

Ok, are you turning the power to the drive on and off in about 5 second intervals? it should take about 2 cycles or so.

I was doing the 2 second interval, but it wasn't helping at all.. But I've read that the guy who created this had to reboot his PC (turning the 360 off, of course) in order to start reading properly, so I just figured, I'll try that..

Anyway.. the BenQ drive takes like 3 seconds to power off (stop spinning), so I took 3 seconds to turn it on again after I've been asked to press the Y.. and that happened just once (giving me the Status: 0x51).. all the other attempts the reading and flashing started right after I've turned on the 360. No more 0x51 for me. ^^


PS: Confirmed working on a Via 3120.. (they said it was needed a 6xxx version)..