Print

[mrbackup2007]

Hi all, i've fixed my problem and I hope this helps yall. I'm Using a A8N-SLI DELUXE, to do the ms25 was easy as pie, but when it came to the ms28 here is what I had to do to get
it to flash using the badflash technique.  Firstly, I entered my bios and went to where in my settings I had my plug & play and set resources controlled by manual and then under irq resources I set all except for one to reserved, just incase, the one I set assigned to pci device was irq-15. Under Ide, I disabled Ide channel 1, Ide dma transfer access, sata port 1, 2 and 3, 4, and last but not least, Ide prefetch mode to disable. Then I disabled PCI IEEE 1394a, and Silicon Sata Controller, and last but not least again, I set HDD Smart Monitoring to disabled. I have had no more problems reading/writing with my sy-via-150 since. I hope this helps many others with simular problems, or atleast the same chipset with the same situation, peace out to all.....  XS we all love you!!!

[mrbackup2007]

anyone thinking about trying what I have listed above, think again for the time being, as of now, I sent the command mtkflash w /m /sata xtreme.bin and to my suprise it said chip erasing..... chip erase... and just hangs, is there something i'm missing for this drive? I can still access the drive and get the reading up to 3% and I can still erase, and neither require the bad flash techinque anymore, i've seen where people could still flash them if they had there original, and I have my original times 7 all over my drives, but still, there is no way to put it back as of now, if anyone can help, please leave me a message, reply to this post, or email me at [email protected]!