Print

[SpankIt]

SATA PCI CARD: Creative I/O VIA-15R SATA Raid + ATA133 COMBO PCI CARD w/ VIA VT6421L Chip set (link to the one I purchased)
XBOX 360 DVD-ROM DRIVE: Samsung MS25 Flashed w/Xtreme 3.3

Im using the Xtreme Boot Maker 0.3.6 and the NTFSDOS disk method. Every time I try to run samread.bat MTKFlash opens up it jumps to the next line and then it just stops at Port:170 master/Slave: b0 and stays there. I'm trying to upgrade to a new firmware although before I do that I wanted to try and make sure that it was able to read the current firmware before I tried flashing a new one. Can anyone help me with this issue?

Thank you

-Pat

This post has been edited by SpankIt: Dec 2 2006, 05:44 AM

[SpankIt]

UPDATE: Here is the process that I am doing.

1) Build the custom MTKFlash using the Xtreme Boot Maker 0.3.6
2) Boot PC with NTFSDOS
3) Type in "mtkflash r /m orig.bin" (without the "")
4) Turn on the Xbox 360 Press Enter


Then the pc freezes and goes nowhere. Just sits at C:\XBF\mtkflash r /m orig.bin with the _ blinking. Sounds like maybe when the power is turned on the keyboardstops working. Anyone have any ideas here? Im all out of em.

[cloudspear]

i have a question. it seem that card also support for ide hard drive since it said 2 sata plus 2 pata. i been looking for a pci ide card and if this have support for sata and ide then i will definally buy it.

[SpankIt]

Can anyone help me with this issue?