Topic: Help Ms 28 Flashed Ok With Vcc Method But E65 Error (Read 42 times)

binke008 · « **on:** September 27, 2006, 08:40:00 AM »

I have flashed my Sammy MS28 correctly with the vcc switch and x360sam 0.3.
After putting everything together, I'm getting a red flashing light (bottom-right) and the error E65. (IMG:style_emoticons/default/sad.gif)
Do I need to resolder the resistor after removing the switch? (IMG:style_emoticons/default/uhh.gif)

cerealkillajme · « **Reply #1 on:** September 27, 2006, 08:52:00 AM »

Yes after you remove the wires/switch you need to put the resistor back in place. Or lay a line of solder on the 2 points to connect them (the resistor is 0 ohms).

binke008 · « **Reply #2 on:** September 27, 2006, 08:55:00 AM »

What was I thinking??? Thanks for your help.. Will do it right now! (IMG:style_emoticons/default/biggrin.gif)

binke008 · « **Reply #3 on:** September 27, 2006, 04:28:00 PM »

Finally its done and working... Thanks for your help cerealkillajme (IMG:style_emoticons/default/smile.gif)

Author Topic: Help Ms 28 Flashed Ok With Vcc Method But E65 Error (Read 42 times)