Print

[peja43916]

So I got tired of hearing how people bricked their drives because they crossed the wrong wires so I decided to take some CLEAR pictures of which wires to cross. Basically where the red spot is where you need to put the wires in . This couldn't get any clearer. You can tell which is the top and which is the bottom of the drive by looking at the SATA connector on the righthand side. Hope this helps.


(IMG:http://i5.photobucket.com/albums/y192/peja43916/Picture-007.jpg)
(IMG:http://i5.photobucket.com/albums/y192/peja43916/Picture-005.jpg)

[ILLusions0fGrander]

nice job.. if those are in fact the right wires  

[peja43916]

QUOTE(ILLusions0fGrander @ Jun 27 2006, 06:49 PM)

nice job.. if those are in fact the right wires  (IMG:style_emoticons/default/biggrin.gif)

Yes, I triple checked and they are correct.

[Bradl3y]

Good work, i almost did it the wrong way thinking the diagram in the guide was looking at it from the side with the holes not the side with the wires coming out, but then i thought about it harder and realised i was wrong.

[peja43916]

QUOTE(Bradl3y @ Jun 27 2006, 07:15 PM)

Good work, i almost did it the wrong way thinking the diagram in the guide was looking at it from the side with the holes not the side with the wires coming out, but then i thought about it harder and realised i was wrong.

 I think alot of people made the same mistake. I almost did at first.

[ben1989]

use a 10k resistor insted of a piece of wire its safer

[coppertop uk]

well i did make that mistake and sort of got a nice looking 360 doorstop lol. believe me i did not make the same mistake on my 2nd xbox 360. these pic's would of helped so very good work