Lets have you start off by getting the new version of smc_io released yesterday. It is on the front page here at x-scene.
When using bestpigs tool make sure have selected make a custom freeboot.
You will find smc.bin in the data folder.
Move it into the \smc_util_v1.0a\smc_util\ folder
Then run smc_util in "io" and "interactive mode". See my example below.
Once it is done copy your smcnew.bin file into the data folder. Rename it to smc.bin and close the data folder. Let bestpig tool finish and you should be good to go.
CODE
C:\smc_util_v1.0a\smc_util>smc_util io smc.bin smcnew.bin /i
*** Xbox 360 SMC Utility ***
*** Version 1.0 by Blackaddr ***
*** Xbox 360 SMC I/O Config Utility ***
*** Version 0.3a by Blackaddr ***
INTERACTIVE MODE
1 - ARGON_DATA (Ring of light board)
2 - DB1F1 or alternate
3 - AUD_CLAMP (Q2N1)
4 - TRAY_OPEN (DVD power cable or connector)
Which I/O for TMS? [1-4]: 3
...using CC
Which I/O for TDI? [1-4]: 4
...using CF
Found the PCIe Start Write Bit bug @ 0x2E9E ...patched PCIe SWB bug..
Found the TMS code at 0x2DC3 and 0x2DCB ...patched TMS output...patched TMS delay.
Found the 1/4 TDI code at 0x2E23 ...patched TDI output.
Found the 2/4 TDI code at 0x2E49 ...patched TDI output.
Found the 3/4 TDI code at 0x2E60 ...patched TDI output.
Found the 4/4 TDI code at 0x2DB4 ...patched TDI output.
Found the TCLK delay code at 0x2DFA ...patched TCLK delay.
*** ARGON_DATA not used, attempting to remove ROL lockout code during JTAG ***
Found the ROL disable code at 0x2D9F ...removed ROL disable.
Found the ROL enable code at 0x2DA9 ...removed ROL enable.
The output file smcnew.bin must be re-encrypted before it can be flashed to the NAND.
Which I/O for TDI? [1-4]: parts says ERROR, couldn't find TMS data pattern. any clues as to why?
wait silly question prob but here goes, do i need to connect my 360 dvd drive to the pc to do this?