hello,
Today, i finally got my PC's LPT port to recognize my 360. I dumped the NAND twice, and both dumps matched each other perfectly. I had a exploitable CB with no bad blocks, so i proceeded to follow these steps:
nandpro nand1.bin: -r16 rawkv.bin 1 1
nandpro nand1.bin: -r16 rawconfig.bin 3de 1
nandpro XBR.bin: -w16 rawkv.bin 1 1
nandpro XBR.bin: -w16 rawconfig.bin 3de 1
I then did:
nandpro lpt: -w16 XBR.bin
nandpro finished with no errors, so i figured it was all done. However, when i try to turn on my 360, i get RROD 0022 with the diode JTAG method (excluding diode on the bridge) (for xenon) and i get the console to show the logo but then gives E64 with the 3 330 ohm resistor method.
Where did i go wrong and what should i do? I no longer have access to the PC with the LPT port btw... so keep that in mind. If I absolutely need to redo it, i suppose i can try to borrow it again.
Author
Topic: E64 Or Rrod After First Flash (Read 85 times)