Topic: Jtag Saver V1.0 (Read 963 times)

harleywastaken · « **Reply #75 on:** May 05, 2010, 04:02:00 PM »

QUOTE(Haygar @ May 1 2010, 02:56 PM)

but it's not like you can go out and just grab a new jtag-able box off the shelf now!

it's not that hard to find 3rd party refurb xenons at or under 6xxx, still wrapped in plastic.

stuntz0rZ · « **Reply #76 on:** May 19, 2010, 03:13:00 AM »

is there any1 that are selling these jtag savers pre assembled? this site is no good http://www.360usbspi.com/ as it says sold out for the past 2 months

thethinker360 · « **Reply #77 on:** May 19, 2010, 05:06:00 AM »

get a Cygnos360 v2 man!

stuntz0rZ · « **Reply #78 on:** May 23, 2010, 07:30:00 AM »

well since i cant fiind a pre assembled jtag saver, i guess i will!

Which one should i get? The Cygnos360 V2 or the V2 Rev. F?? I'll be installing it in a resident evil elite which has a 16mb nand

This post has been edited by stuntz0rZ: May 23 2010, 02:31 PM

thethinker360 · « **Reply #79 on:** May 27, 2010, 07:05:00 AM »

for a 16Mb board you can get Rev E or Rev F.

at VGCrepairs.com the Rev. E is cheaper than Rev F. and you have the advantage that you can have two different hacked dashboards. (e.g. two different regions with freeboot or xbr images)

F is a bit easier to install but does not contain a secondary NAND.

so if I were you i would grab a revision E. only people with 256 or 512Mb jaspers need to use F

TicTac XD · « **Reply #80 on:** August 14, 2010, 04:16:00 PM »

Author Topic: Jtag Saver V1.0 (Read 963 times)