xboxscene.org forums

Author Topic: Assistance With New Nme 2.0 Install  (Read 61 times)

wizdawg

  • Archived User
  • Newbie
  • *
  • Posts: 7
Assistance With New Nme 2.0 Install
« on: January 07, 2008, 02:01:00 PM »
QUOTE(ahamade @ Jan 5 2008, 10:43 PM) View Post

Hi everyone, I just finished installing an NME 2.0 in my Benq Xbox 360 Elite.  I put a backup disc in but the xbox just reads it as a normal DVD.  I am wondering if there is a way to tell if the NME is installed properly and working.  Is there an LED on the chip itself?  Also I wired it into the frontpanel of the xbox but I am not sure what that is really for, is a light supposed to come on if its installed and working properly?

Thanks for any assistance ahead of time!



I may be wrong, but is there a connection to the front pannel because you need to hold the power button for 1 sec to activate the chip on benq drives?
Logged

ahamade

  • Archived User
  • Newbie
  • *
  • Posts: 3
Assistance With New Nme 2.0 Install
« Reply #1 on: January 07, 2008, 04:11:00 PM »
QUOTE(wizdawg @ Jan 7 2008, 10:37 PM) View Post

I may be wrong, but is there a connection to the front pannel because you need to hold the power button for 1 sec to activate the chip on benq drives?


I actually got it all working... the problem had to do with the way I was burning my backups.  I do have 2 wires running to the front panel.  Also Have 2 wires from the back where the USB and Network connections are at.  Then there are the 4 connections within the drive itself.  I installed my chip on the outside of the drive on top of it.  I used a dremmel to cut a slot in the back of the drive case to allow the wires to exit without a problem.

Its all working great now!
Logged

tameone

  • Archived User
  • Newbie
  • *
  • Posts: 19
Assistance With New Nme 2.0 Install
« Reply #2 on: January 15, 2008, 04:48:00 PM »
QUOTE(ahamade @ Jan 8 2008, 12:47 AM) View Post

I actually got it all working... the problem had to do with the way I was burning my backups.  I do have 2 wires running to the front panel.  Also Have 2 wires from the back where the USB and Network connections are at.  Then there are the 4 connections within the drive itself.  I installed my chip on the outside of the drive on top of it.  I used a dremmel to cut a slot in the back of the drive case to allow the wires to exit without a problem.

Its all working great now!


what where you doing wrong with the backups maby i am doing the same thing wrong.
Logged

letsmod

  • Archived User
  • Sr. Member
  • *
  • Posts: 311
Assistance With New Nme 2.0 Install
« Reply #3 on: February 22, 2010, 10:47:00 AM »
"Q" is the switch to turn on NME2 with a  BQ and the rear one turns the LED off, thus there is 2 wires to the front panel
Logged