Print

[davinci66]

QUOTE(Son AK47 @ Dec 20 2007, 06:16 PM)

I had the same problem when i first started writing the hack fw to chip. both on xp and vista.

1) what i did was check my soldering points (touch up), downloaded globe_flash_v1.3 again. extracted. get file  ftd2xx.dll from \drivers\i386 folder, copy to main app folder.
2) run the app (disconnect - connect in device). click on original flash tab, read my orig fw. save it in the app folder.
3) copy ixtrem fw and globe fw (dl globe fw need to be split) to app folder.
4) click on setting tab select dual mode enable. on the hack tab select fw for each bank. click write. "write and verify complete". Ever since, that problem did not reoccur.

Hopefully this too work for you,
if not successful repeat 4) each time rebooting x360.

- when usb cable is connected to comp and pcb board, tx and rx light on, when x360 is off.
- when x360 on, it doesn't matter if pcb fw0 light on and fw1 light off or fw0 light on and fw1 light on.
- globe mention e65, but i got e64. (just for info, not make any diff i think)

SIDE -> careful with globe chip board mounting, might touch the drive head. cause dvd reading problem and damage drive. use strong double sided tape and duct tape or glue gun. to stick against main board. check enough gap between board and head drive (move head in and out)

 (IMG:style_emoticons/default/biggrin.gif) Just finish flashing Benq drive with dosflash (IMG:style_emoticons/default/biggrin.gif)  Hope globe360 team find ways to chip the benq with the globe360 v2. eg benq easy connect pcb.

Hmmm I think I found it now.... "Globe-360Firm_TS-H943-5.3d_Hitachi059B_2.3S.bin" is that it?
But did you use A/B/C or D???

[Son AK47]

QUOTE(davinci66 @ Dec 21 2007, 08:15 AM)

Hmmm I think I found it now.... "Globe-360Firm_TS-H943-5.3d_Hitachi059B_2.3S.bin" is that it?
But did you use A/B/C or D???

I get my goodies from xbins, which i trust.
from xbin only show Globe-360Firm_TS-H943-3.3_Hitachi059_2.1.bin not
Globe-360Firm_TS-H943-5.3d_Hitachi059B_2.3S.bin. where u got this, be careful.

btw, the Globe-360Firm_TS-H943-3.3_Hitachi059_2.1.bin need to be split. to get individual fw.

app close when writing - this also maybe cause by corrupt fw.