Print

[yayo559]

I just installed my xeno-360 modchip on my 47dj drive.  I'm sure everything is wired correctly.  When I press the eject button, the led on the modchip turns on right away.  I hold it for 5 seconds and it just stays on.  I put in a backup and I get the "Put the disc into a xbox 360" message.  When I turn on the xbox via the power button, the led on the modchip stays off, but when I put a backup in, it still recognizes it but gives me the error message again.  Then I press eject, and the led on the modchip turns on.  I find this very weird.  Like I said I'm very sure that all the connections are good.  My original games still work.  I know you are supposed to turn on the chip by holding down the eject button for 5 seconds and mine turns on as soon as I press eject, whether from standby, or if the xbox is already on.  Any help would be greatly appreciated.  Thanks in advance.

[yayo559]

I've checked the continuity between the connections many times and all seem ok.  Maybe it's a bad chip?  Has anyone else had problems like this with the xeno 360 chip?

[LIVE Prophet]

Try maybe an alternate ground point.  Solder the GND wire from the chip to the right side of where the dvd power cable plugs in on the dvd board.  I have posted this in other topics so if you want a picture of it just look a few topics down.

[yayo559]

Ok, I'll try the new ground point and let you know how it goes.  Thanks for the tip.

[LIVE Prophet]

Let me know how it goes.

[LIVE Prophet]

Any progress?

[echto]

If you can post a pic of the soldering job that would help.  Lets see that handy work!

[LIVE Prophet]

Im just waiting for him to reply with any sort of response!