Topic: Xeno 360 Wire #1? (Read 59 times)

Schmutty · « **on:** August 28, 2007, 08:05:00 PM »

Xeno 360 Hatachi Rom 47...Where exactly do you soilder wire #1 on the eject button??? It says the leg??? Can anyone help me to where exactly it goes. Thanks all!!!

LIVE Prophet · « **Reply #1 on:** August 29, 2007, 08:17:00 PM »

(IMG:http://img405.imageshack.us/img405/8240/xbox56rx1.jpg)

When looking at the eject button this way, the little pin/leg on the right side is where you solder your wire. Make SURE you do NOT get solder on the metal surrounding the eject button, as you will then short out everything if you do!

This pin is small as you can see. What I did was just put some solder on your iron, heat up the pin first to where there is solder melted to it, then pre-solder your wire also, and just melt the wire into the solder joint already on the pin.

Schmutty · « **Reply #2 on:** August 29, 2007, 08:43:00 PM »

Thats what I needed! Thanks so much!

LIVE Prophet · « **Reply #3 on:** August 30, 2007, 07:43:00 PM »

just glad i could help (IMG:style_emoticons/default/biggrin.gif)

so is everything working now?

Author Topic: Xeno 360 Wire #1? (Read 59 times)