Print

[eriksson25]

Hi, I have jtagged 30+ boxes with my H2148 usb reader. But it was a while ago like 1 year, so it has just been lying around. Then I got a new box from a friend to Jtag so I digged it up and prepered everything. In this time I have updated my computer to Win 7 x64 (from xp 32 bits). So had some troble with the drivers before I got them working. But when I tried to read my nand with nandpro, all I got was the error cant detect flash controller. So thinking it might be since I have a x64 system now I powerd up my laptop that has xp 32bits and installed everything there. But same error no mather what I did, and I know that the solder points are correct.

Oki, I started thinking that maby something was of with my reader, so I planed to reprogram it with the hex from nandpro20e.

But after installing flashmagic and resolder my programmer FT232R I have no luck at all. I am able to read the device siganture. But when trying to program it just says Failed to send data to device.

So now I have a eresed device, and I am unable to reprogram it. I am thankfull for any help.

Some information maby needed.

Settings in flashmagic
Device:LPC2148
Com:com 7
Baud rate: 9600
Interface: none (ISP)
Oscillator: 16000

I have soldered like following link, exept I have a other programmer. http://img188.imageshack.us/img188/2601/lc...2shiftersmd.jpg

Any other information needed, just ask.

[eriksson25]

Oki, this is typical, Just becouse I posted here after several days of trying it worked, it is now programmed with the hex from nandpro20e

The diffrence I did was baudrate:38400 and oscillator:12

But now to next problem, I cant get it to be detected by nandpro, still gets "could not detect a flash controller"

Any idees?