Print

[lcarbutt]

Hi there. I have been using a nand-X to read my 360's nand but I keep getting a differential. Im fairly certain it's not the soldering (for the record I did the pin header install) the difference is always small, I have read my nand 20 times, in TOTALCOMMADER it only shows 1-5 differences, some of them actually do match. When using nandcompare it's always the same block thats different, and it's a block that comes up as BAD when im reading it in nandpro. There is a second bad block as well but that does not seem to cause a differential.

Any advice would be very welcome thx.

[onlyXMan]

if you have physiacal bad block then dumps should be identical, then you have soldering problem

[lcarbutt]

QUOTE(onlyXMan @ Dec 2 2010, 10:29 PM)

if you have physiacal bad block then dumps should be identical, then you have soldering problem

 Well at first I installed with QSB. that had same error so I thought it was soldering. Thats when I removed the QSB and replaced with pin header. THE VERY SAME mis-matched block appeared, i resoldered the pins 3 times, the same mis-matched block appears. And it's always a block that appears as bad when I read it with Nandpro. If I re-map the bad block wont the mismatch become irrelevant?? Also i have managed to get 3 matching nands flashes, albiet from 20 dumps, the other dumps just had that one difference.