Print

[soapy_ninja]

i have dumped it 4 times now and 1 and 4 are the same but the rest are different from each other.
would it still be ok to countinue with the jtag should i use the first one or the 4th one?

[p4r0l3]

I'd dump it again and make sure that your fifth dump is the same as 1 and 4 just to be sure.

You may want to check your wiring, because if you're getting different reads 50% of the time, there's a good chance you won't get 100% good data written to your nand when you try to write with your current setup.

[chatterx]

Is your lpt cable properly grounded?? You will get this if it isnt

[hemelinger]

You have 2 matching dumps ! Perfekt, just continue. It does not really matter witch dump you take, since all you really need is you kv and config.

[soapy_ninja]

i dumped it again 5th matches 4 and 1st, i ran the rawkv and config commands, reflashed it and i get a e79 error, im about to flash back to the original, to see if it makes it go back to normal.
each time i dumped them i got error 250 block 27b  and  2bf,
which wire is the ground i will check it and resolder it to make sure it is good?
should i just try reflashing it with the modified one to see if it just did it bad the one time?

[hemelinger]

If you  get an error  reading 250 block 27b and 2bf you most likely have bad blocks on your nand. Do get this error when writing to nand ?

[soapy_ninja]

yeah i got it when writing to the nand too.

i flashed it and it didnt turn on at all no lights or anything, i read that if you flash it again it might fix it so i am doing that again.

[soapy_ninja]

alright i reflashed it and it is back to the e79 error,

i found this  http://forums.xbox-scene.com/index.php?showtopic=699571
it says to check the jtag wires with a multimeter, should i just retry soldering all the points on the jtaging parts.

[hemelinger]

I would remap the two bad blocks and then flash again.

[soapy_ninja]

i resoldered all of the points and it still gives a e79 error
i can push the dvd drive button and it will open and boot into xell though  
it just wont boot into the normal dash
what am i doing wrong.

[hemelinger]

You need to remap the bad blocks. What kind of nand do you have ? 16 MB ...

[soapy_ninja]

how do you remap the bad blocks?
It is a xenon so 16mb

[hemelinger]

use flashtool v.94 to verify the positions of your bad blocks. Then you can use bad block mover tool, or remap them with nandpro.

[soapy_ninja]

i give up

[chatterx]

Did you try moving the bad blocks?

This post has been edited by chatterx: Oct 5 2010, 03:05 PM