Topic: How's My Jtag Wiring? (Read 61 times)

c0d3_z3r0 · « **on:** February 22, 2010, 10:25:00 AM »

How's my jtag wiring?
It works fine, I just want some feedback on how it is or how I should improve it.

PGX · « **Reply #1 on:** February 22, 2010, 11:02:00 AM »

Your wiring is O.K, but you stripped too much wire off the ends, which in turn could possibly create a short.

c0d3_z3r0 · « **Reply #2 on:** February 22, 2010, 11:56:00 AM »

I stripped off 3mm of wire off the ends.
How much wire should I strip off?

thwack · « **Reply #3 on:** February 22, 2010, 12:10:00 PM »

Na - think you stripped the right amount off. My only criticism would be you should have used shrink-fit tubing where you've connected the wire to the switching diodes - that could short out.

c0d3_z3r0 · « **Reply #4 on:** February 22, 2010, 12:20:00 PM »

I'm using electrical tape to keep it from shorting out on the metal case right now
But I'll try the heatshrink tubing, it would look better too.

_less_than_zero · « **Reply #5 on:** February 24, 2010, 09:20:00 AM »

that's sweet, did you at least use flux during soldering? if not i bet it was a nightmare to solder lol.

c0d3_z3r0 · « **Reply #6 on:** February 24, 2010, 02:43:00 PM »

I used flux for the diodes, but not anything else.

Author Topic: How's My Jtag Wiring? (Read 61 times)