Topic: Lost My Backup Nand Need Replacement, Please Help (Read 49 times)

sirox · « **on:** January 01, 2010, 07:12:00 PM »

If the dump on the picture is your latest than you are able to do the jtag-hack with xbreboot and you xbox will boot again.

jayboy86 · « **Reply #1 on:** January 01, 2010, 09:06:00 PM »

tried flashing this to the 360 powers on, power comes on but thats it just sits there no other lights.
someone told me i have take the wiring out or it wont boot, is this true?

sirox · « **Reply #2 on:** January 01, 2010, 10:57:00 PM »

if you mean the orginal flash, yes you have to take the wiring out.

jayboy86 · « **Reply #3 on:** January 02, 2010, 07:01:00 AM »

what about if i use xbreboot? i have to inject my kv and config datas into the xbreboot image dont i

do i have to remove the wiring for that? if i do theres my problem

Ranger72 · « **Reply #4 on:** January 02, 2010, 08:40:00 AM »

QUOTE(jayboy86 @ Jan 2 2010, 09:01 AM)

what about if i use xbreboot? i have to inject my kv and config datas into the xbreboot image dont i

do i have to remove the wiring for that? if i do theres my problem

Yes you need to inject your KV and config. Yes you need to have the jtag wires installed. No you do not need to leave the lpt wires installed but that is up to you it will work ether way.

littlestevie360 · « **Reply #5 on:** January 02, 2010, 12:00:00 PM »

QUOTE(jayboy86 @ Jan 3 2010, 03:17 AM)

i guess i have a bad kv then,

a bad kv wouldnt just cause it to hang like that

check your nandpro log to make sure that you dont have any bad blocks and if you do, remap them

Author Topic: Lost My Backup Nand Need Replacement, Please Help (Read 49 times)