Print

[xxpittbullxx]

QUOTE(sirox @ Dec 13 2009, 02:28 PM)

Ok, i did some tests, as i wrote this morning the orginal nand without jtag still works.
JTag with diods ( and wire bridge ) -> RROD
JTag with diods ( and wire bridge with diod ) -> One Red LED and E 71
JTag with 3x 330Ohm resistors -> One Red LED is on and i get an error on the screen

is the way wrong i'm flashing ?
nandpro nand1.bin: -r16 rawkv.bin 1 1
nandpro nand1.bin: -r16 rawconfig.bin 3de 1

nandpro XBR.bin: -w16 rawkv.bin 1 1
nandpro XBR.bin: -w16 rawconfig.bin 3de 1

use badblockmover to XBR.bin ( i have bad blocks at 6F,72,73 and ED )

nandpro lpt: -w16 XBR.bin

regards,
sirox

yea your jtag wires have nothing to do with being able to read and write to your nand(just your lpt wires do) but they are what makes xbr or xell boot
all your nandpro commands are correct
recheck your connections then try again

[geron]

After flashing I got the RROD. I used someones advice and just wrote the Rawkv.bin to XBR and it worked! Im not sure exactly what Rawconfig does but I did notice it asked me to setup language/region/resolution when it booted. Everything works fine though.

[sirox]

ok i did some more testing

@xxpittbullxx: i think my jtag-connections are ok, because wenn i put a controller on the backside-usb i can boot xell ( it starts and sad vmlinuz not found ) but it start booting.

My Cx Section look like this:
CB: 1888    Pairing 0xDD70E8    LDV 0
CD: 1888    Patch 0: 7363          LDV 9
CE: 1888    Patch 1: 6717          LDV 8

Do i have to repack XBReboot, because i have CB: 1888 ? xbreboot is made for 1920 right ?

My aktual state is:
Power Button: E74
Controller on Backside: starting xell but vmlinuz not found ( but i didn't mind i want not to start linux i will start some XEXLoader )

[xxpittbullxx]

QUOTE(sirox @ Dec 14 2009, 05:16 PM)

ok i did some more testing

@xxpittbullxx: i think my jtag-connections are ok, because wenn i put a controller on the backside-usb i can boot xell ( it starts and sad vmlinuz not found ) but it start booting.

My Cx Section look like this:
CB: 1888    Pairing 0xDD70E8    LDV 0
CD: 1888    Patch 0: 7363          LDV 9
CE: 1888    Patch 1: 6717          LDV 8

Do i have to repack XBReboot, because i have CB: 1888 ? xbreboot is made for 1920 right ?

My aktual state is:
Power Button: E74
Controller on Backside: starting xell but vmlinuz not found ( but i didn't mind i want not to start linux i will start some XEXLoader )

Not sure i follow you
but you can try the other image if the one your using isn't working for you