xboxscene.org forums

Author Topic: Jtag, Xenon, Error 0022  (Read 65 times)

thwack

  • Archived User
  • Hero Member
  • *
  • Posts: 785
Jtag, Xenon, Error 0022
« on: December 07, 2009, 01:17:00 AM »
0022 generally = bad NAND flash. Nandpro can be a bit jumpy when running first time in the CMD window. Try opening the CMD window, and reading a tiny bit of your NAND (say nandpro lpt: -r16 0X0128 1 - no need to keep this file, just for warming up nandpro), then try writing to your NAND.
Logged

OliSykesIsPro

  • Archived User
  • Newbie
  • *
  • Posts: 20
Jtag, Xenon, Error 0022
« Reply #1 on: December 08, 2009, 05:34:00 PM »
QUOTE(Bukmop @ Dec 7 2009, 09:39 AM) View Post

Recently Iposted about similar problem. Are you using 2 diodes and 1 wire? Try to replace wire by 330 Ohm resistor as me. It should work smile.gif


i'm using 330 ohm resistors.



I haven't booted XELL yet so no cpu key, but this is what I get in flash dump tool

IPB Image


the nand isnt too new is it?
Logged

torne

  • Archived User
  • Sr. Member
  • *
  • Posts: 383
Jtag, Xenon, Error 0022
« Reply #2 on: December 09, 2009, 05:19:00 AM »
You have installed the 8498 dashboard, so no, your xbox cannot run XeLL. CB version must be 1921 or lower on a Xenon for it to work.
Logged

krzysiek033

  • Archived User
  • Newbie
  • *
  • Posts: 5
Jtag, Xenon, Error 0022
« Reply #3 on: February 05, 2010, 03:28:00 PM »
I have the same thing on my falcon. Only difference is that My pc wont detect flash controller anymore. I tried shorting nand with no luck. Anyone have any dea what to do?
Logged