Topic: Possible Ban-proof Switch (Read 358 times)

alikaz · « **Reply #30 on:** December 13, 2002, 01:33:00 PM »

man wtf? now its like all fuked up, when i start it, it jus strats for 2 secs(no vid output), shuts down, starts agin shuts down agin then starts and the green light flashes orange-redish ..NO VIDEO output, in both switch modes, i checked all the wires and alll lookz good,..man PLS help

alikaz · « **Reply #31 on:** December 13, 2002, 01:34:00 PM »

and one more thing how does the cap go? i had one side of it that had like a negative (-) sign on it, so its negative rite? or is it positive?

Captain_Dunsel · « **Reply #32 on:** December 13, 2002, 03:59:00 PM »

1) Look very carefully at the cap to be sure of the symbol. If indeed it is a minus (-) sign, that leg should go to pin 16; if it is a plus (+) sign, that leg should go to pin 32. The remaning leg (obviously) goes to the other pin.

2) Debugging problems like this via this forum are REALLY hard. I'd check your connections at the EEPROM socket (to verify you didn't create any unintentional solder bridges etc while rewiring) and triple-check to ensure that your connections to the mobo are all still good.

3) I assume that you really DID verifty the connection combinations of the switch with a voltmeter or continuity tester... if so, can you explicitly state which pins are, and are not, connected together when (a) the button is in the normal state, and (2) the button is pressed and held in?

CD

alikaz · « **Reply #33 on:** December 13, 2002, 04:56:00 PM »

agight i had enuf, i jus took out my modchip, cut all the wires...and blah blah, but now im getin a error screen(finally some vidoutput) but there is no error code...ne reason?PLS HELP

Captain_Dunsel · « **Reply #34 on:** December 13, 2002, 06:02:00 PM »

Author Topic: Possible Ban-proof Switch (Read 358 times)