xboxscene.org forums

Author Topic: Tsop Flash Help  (Read 131 times)

f34rther34pr

  • Archived User
  • Newbie
  • *
  • Posts: 49
Tsop Flash Help
« on: May 16, 2010, 04:51:00 PM »
i dont really know where to put this, so im just gonna take a guess and put it here. anyway, i've tried to flash my bios using this guide. it says flash not writable yet iv soldered this right points and everything. anybody have any suggestions
Logged

Heimdall

  • Archived User
  • Hero Member
  • *
  • Posts: 3862
Tsop Flash Help
« Reply #1 on: May 16, 2010, 05:04:00 PM »
Are you getting a message similar to:
"Manufacturer's ID 09 Device ID 00"

If so, what is it?
Logged

f34rther34pr

  • Archived User
  • Newbie
  • *
  • Posts: 49
Tsop Flash Help
« Reply #2 on: May 16, 2010, 05:55:00 PM »
QUOTE(Heimdall @ May 16 2010, 06:04 PM) View Post

Are you getting a message similar to:
"Manufacturer's ID 09 Device ID 00"

If so, what is it?

yes thats exactly what im getting. any idea why?
Logged

Heimdall

  • Archived User
  • Hero Member
  • *
  • Posts: 3862
Tsop Flash Help
« Reply #3 on: May 16, 2010, 05:59:00 PM »
That means it's your soldering. Double check that you're soldering the right points for your motherboard, clean the TSOP points, scrape them VERY gently with a craft knife to get rid of any surface oxidisation, and use lots of flux.
Logged

f34rther34pr

  • Archived User
  • Newbie
  • *
  • Posts: 49
Tsop Flash Help
« Reply #4 on: May 16, 2010, 06:22:00 PM »
so remove the solder from the points and resloder them
Logged

xboxmods2977

  • Recovered User
  • Hero Member
  • *
  • Posts: 733
Tsop Flash Help
« Reply #5 on: June 07, 2010, 10:28:00 AM »
Yes. Also, if you have a multimeter, you can check your soldering joints with it. Take a close look at those joints. All 4 points (the two pairs you joined with solder blobs) have traces which lead to either pads or other components nearby allowing you to confirm continuity between your newly bridged points.
Logged