Topic: 320gig Hd Help (Read 40 times)

Dullblade · « **on:** December 08, 2006, 11:28:00 AM »

Hi guys sorry to bother you with this question but i just cant seem to grasp the other converstions...

Im using the v1.3, smartxx v3 chip, flashed with Evox Version M8plus.bin, i used the Slayer auto install version2.7. And have installed a WD 320gig HD. everything works fine but it appears that im not using my full HD space. So first off how do i know if full drive is in use or if i have a lot of free space not beening used. I opened my bio file with EVtool and that bottom left corner said part. 6 takes rest of drive so that makes me think my bios is useing full drive. Do i need to do something else or am i already good to go.

Noooobie.

Dullblade · « **Reply #1 on:** December 09, 2006, 10:20:00 AM »

So nobody has any input about this. Well i guess its just me then. Thanks for your efforts and going out of your way. See you around.

joeshannallie · « **Reply #2 on:** December 11, 2006, 08:18:00 PM »

QUOTE(Dullblade @ Dec 9 2006, 12:20 PM)

So nobody has any input about this. Well i guess its just me then. Thanks for your efforts and going out of your way. See you around.

I have a X3 chip and I had to set my 250gb to master for it to format and show correctly. I hope this helps.

pulawman · « **Reply #3 on:** December 14, 2006, 07:48:00 PM »

not sure if this will help, but I've seen a few posts on hd space not showing up. Most of these people forgot to format their g: partition... might wanna give it a try? hope this helps

skyzerr33 · « **Reply #4 on:** December 14, 2006, 10:40:00 PM »

you need to select partition 6 takes up 137gb and partition 7 takes rest which enable a G drive which you must have on a 320gb hd

What you should be using though is x2 5035 bios and the config.ini goes on e drive

Author Topic: 320gig Hd Help (Read 40 times)