I have a new (old) xbox with an xecuter 2.6 pro chip i think. It wasn't booting any dashes so I made a boot disk to boot it. I figured I'd flash the x2 5035 to it configured with stuff where I wanted it to boot.
I loaded up flashx on my boot disk and told it to flash the x25035.bin I created (used x2 config maker).
FlashX now say Programming... in the upper left of the screen is exactly half way across. its been there for a loong time.
I'm wondering since in the past I've only ever flashed 256k bios' and never changed the dip switches, was I supposed to change any of the dip switches on it to flash a 512k bios?
When I decide to turn this thing off and it probably will be hosed with half a bios on it, what are my options?
I recall there was some cromwell boot disc I could make but can find any info on that at the moment?
I also have the parallel port connection off the chip but have never used it before so don't know whats required there?
Any info is appreciated.
Edit: ok I was able to not panic and found the old dip switch image I had. I set them to 512 for bank 1 & 2 and then it flashed. Only problem now is that purple xecuter rox my box logo.
I have the x2 config maker but still don't see anywhere in there how to load a new logo, what size it needs to be, or where it needs to be stored.
This post has been edited by mrRobinson: May 26 2006, 01:55 AM
