Me and Landon14 just put a X3 chip in my 1.6 xbox. We tried to put the X2 bios on it since we already had a disk. This did not work however and when we have the switch on bank one it will not load.
So we burnt a disk with X3 bios on it. We booted up Flashbios in another bank and then flipped swithces 1 & 2 since X3 is a one megsbyte bios. Flashed fine, xbox turns off. But now in Banks 1 or 2 switched only or together all we get is frag. We tried flashing again same result. Now I have read that 3.03 FlashBios sometimes doesn't work with a 1.6 Xbox. Anyone have any ideas or suggestions?
edite/ Also it turns on and off a few tiems then it frags.
This post has been edited by Alden: Jul 25 2005, 05:46 PM
