i'm having trouble trying to use this software.
i downloaded the programmer software. i run it. connect the chip to the programer, conect the programer via the parallel cable to the printer port. i go to the software and it asks me which port to use. i have tried 378 (default) and 1 (printer port) and even 2.... then i connect the usb to the computer. but nothing it does not detect it.
if you have experience using the programer please tell me what i'm doing wrong.
ps. i had previously installed the chip on the xbox and for the sake of not soldering again, the cables are still atached to the xbox from the chip. do i have to unsolder the conection or not. (i would try it, but i rather have some expert tell me)
thanks.
