I have a v1.4 PAL XBOX set to NTSC-M, with an X3. I made an A/V to VGA cable using JaredC01's diagram as the info for which wires go to where, I made a diagram of my cable (in the diagram it says 670k resistor but it's really a 680k resistor, just a typing error):
With the switches set to VGA mode, (9&10:ON, 11&12:OFF, 13&14:ON) it says no signal input on my Acer AL1716 s 17" monitor. With the switches set to HD mode (9&10:OFF, 11&12:ON, 13&14:ON) it works fine, except that it has a very strong green tint, (changing green to off in the monitor settings doesn't help either, it just changes to a darker grey-ish green). The MSDash doesn't display on the monitor (it says no signal input) although I'm not really bothered about the msdash. The picture is still the same with both the x3 bios with vga patch enabled, & the latest ind-bios with 480p enabled in the animation settings of the config file. I haven't tried the 5001 ind-vga-bios. I am wondering what's causing the green tint (I have the LM1881N wired to the cable (as shown in the diagram). Should I try a 470k resistor instead of the 680k one or could that possibly damage the LM1881N?
Thanks in advance.
