ok so i finally got my mod to work a few works ago and it was running fine for about a week then i learned how to flash (not the best idea) i flashed my x2.2 lite + with a custom x2 4979 that i tweaked the led colors nothing serious i also made one bank boot avalaunch no biggy everything worked fine but i didnt like the leds so i changed those with xbtool ftped into xbox and went to flash this is were everything went to crap i go to flash it erases then it freezes like 10% into flashing so i leave it for like 10-15 mins and turn it off thinking that it might by some miracle had flashed but it didnt like i expected and it fragged so i say ohh well ill just buy the programmer so about a week later i get the programmer flash it with x2cable still fragging so i use the normal 4979, frag so i go back to the one i knew worked 4977, frag so i use x2bm to flash it flashes but doesnt verify so i read it in x2cable its does its thing so i try that, frag so i decide to check the lpc points with a multimeter most read 3.3v with and without the chip except for the 5v and ground and the such so at this point im stumped any suggestions would be great thanks.
