Print

[zxcvbnm]

Just wondering if anyone has had any success with the new Highway Package yet.

I am about to do a 1.5 with the Winbond bios chip and was just wondering if i should use the new Highway pack or just stick with Raincoat 501.

Thanks.....   <

[jip1960]

I downloaded the highway pack last week, just put your 256k bios in the oooooooooooo folder rename to bios.bin boot up mech and in the top line of settings is "Flash with Eurasia" just
accept and flash.Ive done 8 wankbonds since and it's worked perfect each time.Robert at eurasia and Ventura Highway did a great job on this, so when u see the "duck" appear thank them!
*NOTE-use 4979 or 4981 for v1.5
*and if u go to flash bios on evox it will tell u if your solder points are connected ok.  DONT  press the (yellow button)!!!GO back Eurasia and flash with the duck!!! job done.
*Scratch the varnish coating on the tsop points before u solder and they join 1st SHOT.
*Then unsolder the points again (Don't want bill to get one back on us by reversing our reverse)

*"HIGHWAY" those winbond ini settings were from my "just after I pulled my hair out file"
*and i got my v1.5 going with a cheapmod p2-earth / p3-lpc
connection (piss easy) / p9-3.3v and away she goes.
 <

[zxcvbnm]

Hey jip1960, thanks for the reply. I will attempt this on Tuesday and hope everything works out fine

I will post results, once again thanks  <